MITER SAWS

Similar to table saws, the maximum diameter of the blade used on the Miter Saw indicates its description. Miters, like the TRADESMAN Model #8328 and Model #8333, are both 10" units, using a 10" blade for the maximum cutting capacity. The TRADESMAN Model #8325 has an 8-1/4" maximum blade size.

BASIC FUNCTIONS

The main function of the Miter Saw is for the quick and accurate crosscutting in hard/soft woods, plastics, and aluminum extrusions at various angles. Because of the short downward movement of the blade, this function is performed much quicker than can be accomplished on either a Table or Radial Arm Saw. Detent stops at 0', 15', 22-1/2', 30, and 45 degrees left and right, permit easy changing of commonly used angles.

The Miter provides portability from one location to another, making it ideal for out of basement projects or for contractors on the job site. It is invaluable for framing operations where 90 degree or angle cuts in 2" X 4" or 2" X 6" material is required.

Utilizing a Universal motor like the bench table saw, it has high torque for cutting power. Most Miter Saws have a built-in safety electric brake. This feature stops the turning blade once the cutting operation is completed and the trigger switch is released.

COMPOUND FEATURE

The TRADESMAN Model #8328 is a 10" Compound Miter Saw. The compound feature allows bevel cutting to be performed. The bevel operation can be combined with the miter angle to provide compound angles for trim or molding work. (works especially well for crown molding). Positive stops are provided at 0' and 45 degrees, with a bevel indicator scale for angles in between. Accurate cutting can be performed on picture frames, baseboard moldings, door/window framing, chair rails, etc.

SLIDE COMPOUND FEATURES

The TRADESMAN Model #8336 PRO Slide Compound Miter Saw provides all the features found in regular and compound miter saws. In addition, it allows for extended crosscuts up to 12" inches in width. Instead of just a downward movement, the motor assembly rides on ball bearings mounted on precision ground shafts. To operate, the blade is brought forward to the maximum required distance and lowered. The blade/motor assembly is then pushed in a slow and steady action back through the work piece, until the cut is completed.

ACCESSORIES

Besides the purchase of a carbide tipped blade for miter saws, there are other accessories that greatly increase its performance. For finishing projects such as trim/molding, etc. a planer blade (hollow ground) or a 60- tooth carbide is recommended. This will provide the smooth, even cuts required in finished projects like cabinet or furniture making,

SAFETY CLAMP

Used for clamping the work piece to the fence and table, it provides safety to the operator especially when crosscutting any work piece less than 6" in length (as measured from the blade). All cuts must always be clamped and never held by hand.

EXTENSIONS WINGS / STOP BLOCK

Extension wings, used on both sides of the worktable, provide extra support for long work pieces. An adjustable stop block that can be located on the right or left side extension wing, is used for repetitive cuts.